Verify Temperature And Voltage; Saving And Restoring Camera Settings - Dalsa Linea Color CL User Manual

Verify Temperature and Voltage

To determine the voltage and temperature at the camera, use the Refresh Voltage and
Refresh Temperature features found in the Camera Information set.
The temperature returned is the internal temperature in degrees Celsius. For proper
operation, this value should not exceed 75 °C. If the camera exceeds the designated
temperature it will stop imaging and the LED will turn red. Once you have diagnosed and
remedied the issue use the reset camera function.
The voltage displayed is the camera's input voltage.
Note: The voltage measurement feature of the camera provides only approximate results
(typically within 10% and dependent on the voltage drop in the cable). The measurement
should not be used to set the applied voltage to the camera, but only used as a test to
isolate gross problems with the supply voltage.

Saving and Restoring Camera Settings

The parameters used to select, load and save user sets are grouped together under the
Camera Information set of features. There are 8 user sets available and one factory set.
Camera Information
Parameter
User Set Default Selector
User Set Selector
User Set Load
User Set Save
Description of the Camera Settings
The camera operates in one of three settings:
1. Current session.
2. User setting.
3. Factory setting (read-only).
4. Default setting.
The current settings can be saved (thereby becoming the user setting) using the User Set
Save parameter. A previously saved user setting (User Set 1 to 8) or the factory settings
can be restored using the User Set Selector and User Set Load parameters.
4. Camera Operation 
Choices
Select the camera parameters to load when the camera is reset or
powered up as the Factory set, or as User Set 1 to 8.
Selecting the set from the list automatically saves it as the default
set.
Select the Factory or User set to Save or Load.
-Factory Set
-User Set 1 to 8.
Load the set specified by User Set Selector to the camera and
make it the active / current set.
Save the current set as selected user set.
37