Dalsa Linea Color CL User Manual page 67

For example, if the total number of pixels for the specified AOI`s is less than 1 K when
using base Camera Link mode at 85 MHz, the maximum EXSYNC rate can be 48 KHz;
versus 10 KHz if all 8k pixels were output.
Note: The setup of AOI is always with respect to the sensor. Therefore, if you are using the
mirroring mode with AOI, be aware that pixel one will be on the right side of the displayed
image.
In order to set up an AOI for the camera:
1. The AOI mode must first be in the off position.
2. Use the AOI Count to select the total number of AOIs desired to a max of 4.
3. To set up each AOI individual use the AOI Selector to point to the AOI to be set up.
4. AOI Offset X is used indicate the starting pixel of the AOI.
5. AOI Width is used to indicate the width of the AOI.
3. Select area to
set up.
Appendix A: GenICam Commands 
1. Must be off to
set up the AOI.
2. Set up the
number of AOI
desired to max of 4.
4. Select beginning
of selected area
5. Set up width of
selected area
67