Selecting Ip Address - UTC Fire and Security KiddeFire Systems ARIES NETLink BACnet User Manual

6. Specify a BACnet Interface Module IP Address. The IP address can be entered manually or
selected by clicking on <1. Get FS IP address>. Refer to Figure 4-2 below.
7. Press the <2. Take Log> button. While the utility runs, a few DOS prompts will flash
across the monitor. Do not click or type anything in response to these DOS prompts. This
step may take a few minutes depending on whether "Short Log" or "Long Log" has been
selected and the speed of the PC/laptop. When the utility is finished, you will be presented
with a log of events that have occurred.
P/N 06-237214-002
Press here to retrieve
the IP address.
Figure 4-2. Selecting IP Address
Select a log type.
Press the Take Log
button.
Figure 4-3. Taking a Log
4-3
Type in the BACnet Interface
Module IP address. Default
is 192.168.1.24
Troubleshooting
June 2012