Page 2
VIDEO INPUT VT7430-2DRDT 4 CHANNEL DIGITAL VIDEO TRANSMITTER - DATA (IN/OUT) - 7 RS422/ 2W RS485 + DATA (IN/OUT) - 6 2 CHANNEL RS232 DATA IN - 5 DATA TRANSCEIVER RS232 RS232 DATA OUT - 4 International - DATA OUT - 3 RS422/ 4W RS485 + DATA OUT - 2...
Page 3
VT/VR7430-2DRDT Ground RS232 DATA Data Input Data Output Ground - Data In RS422 DATA + Data In - Data Out + Data Out 2-WIRE - Data In/Out + Data In/Out RS485 DATA 4-WIRE - Data In + Data In RS485 DATA - Data Out + Data Out...
Page 4
VT7430-2DRDT TX RX TX RX CARRIER DETECT CHAN 3 CHAN 4 CHAN 1 CHAN 2 POWER CAMERA ON Carrier Detect LED: RED to GREEN Channel A Data: Switch 1 Channel A Data: Switch 2 LED: RED to GREEN Electrical Data Transmitted Channel A LED: RED to GREEN Optical Data Received Channel A Video Input From Camera: Channel 1...
Page 5
VR7430-2DRDT TX RX TX RX TRANSMIT POWER CARRIER REMOTE VIDEO ON RECEIVER LOCKED CHAN 1 LOCAL VIDEO ON Channel A Data: Switch 1 Channel A Data: Switch 2 Electrical Data Transmitted Channel A LED: Illuminates Optical Data Received Channel A LED: Illuminates LED: Illuminates Video Present at Transmitter: Channel 3...
Page 6
INSTALLATION INSTRUCTIONS FOR ADDITIONAL COMPONENTS REQUIREDTO MEET EMISSION REQUIREMENTS ON THE VR74XX-2DRDT SERIES STAND ALONE UNIT. Install Supplied EMI Filters (IFS P/N FL28A0640-0A0 or Steward P/N 28A06040-0A0 on each data cable as shown. The data cables must have two turns through the clamp!
Page 7
INSTALLATION INSTRUCTIONS FOR ADDITIONAL COMPONENTS REQUIRED TO MEET EMISSION REQUIREMENTS ON THE VT74XX-2DRDT-R3 and VR74XX-2DRDT-R3 Series RACK MOUNT UNITS. GASKET INSTALL SUPPLIED CONDUCTIVE FOAM GASKET (IFS P/N MMRFGSKT 375X500 or CHOMERICS P/N 82-122-74021-09600) CUT TO 3 INCH LENGTH AND PLACE ON TOP RAIL OF THE RACK (AS SHOWN), WHERE THE UNIT IS TO BE INSTALLED.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by International Fiber Systems, Inc.
Page 9
Contacting us For help installing, operating, maintaining, and troubleshooting this product, refer to this document and any other documentation provided. If you still have questions, contact us during business hours (Monday through Friday, excluding holidays, between 5 a.m. and 5 p.m. Pacific Time). Sales and support contact information North Toll-free: 855.286.8889 in the US, including Alaska and Hawaii;...
Page 10
Product Disassembly Instructions for WEEE Per European Directive 2002/95/EC Waste Electrical and Electronic Equipment Required Tools: One number 2 Phillips (crosstip) screwdriver. One number 2 flat screwdriver. For the enclosed box version: 1. Locate and remove box cover securement screws. Usually, but not limited to, at least 4 screws.
Need help?
Do you have a question about the Interlogix VT7420-2DRDT and is the answer not in the manual?
Questions and answers