Permissible Mounting Positions Of The Panel Front; Type Of Fixation - Siemens SIMOTION P350-3 Manual

4.8.4

Permissible mounting positions of the panel front

Approval
Certain mounting positions are approved for the SIMOTION panel fronts.
Permissible mounting positions for the SIMOTION panel front
Figure 4-4
Vertical installation and deviations of up to 20° and – 20° in the given directions is
permissible.
Note
The mounting position illustrated has been tested and approved.
In the event of deviations from it, you might need to have additional tests carried out to verify
compliance with the general conditions applicable for the components used
(e.g. temperature). Siemens can provide appropriate support on request.
4.8.5

Type of fixation

The control unit is secured in the mounting cut-out either with clamps or screws.
NOTICE
Securing with screws is not possible with the 12" touch screen variant.
Select the mounting type suitable for your requirements for the degree of protection.
SIMOTION P350-3 and Panels
Manual, 05/2009
Permissible mounting position of the panel front
Application planning
4.8 Mounting positions and fastening
89