Siemens SIMOTION P350-3 Manual page 56

Hardware description
3.5 MCI-PN board for SIMOTION P350-3
Note
The MAC address can be viewed in the device diagnostics of the SIMOTION SCOUT
Engineering System.
The IP address is set using the SIMOTION SCOUT Engineering Software (HW Config).
Label with MAC address
The MAC address of the MCI-PN board is also indicated on a label on the computing unit.
If the MCI-PN board ...
is integrated into a SIMOTION P complete
system,
has been purchased and integrated as an
optional communication module,
SYNC I/O interface X8/X9 to the IsoPROFIBUS board X4
The supplied ribbon cable (A5E00447905) is used to connect the two modules. See also
Overview of the SIMOTION P hardware installation (Page 18).
Note
• The SYNC I/O cable MUST be plugged in when both modules (MCI-PN and
• The enclosed battery cable does not serve any purpose when the MCI-PN is used as an
56
IsoPROFIBUS board) are used.
optional board (plugged into slot 2); it is not connected.
then the label indicating the MAC address ...
already affixed underneath the rating plate on the
computing unit's housing.
affixed to the module on delivery.
Pull the label off the module and stick it to the
computing unit's housing underneath the rating plate.
SIMOTION P350-3 and Panels
Manual, 05/2009