Siemens SIMOTION P350-3 Manual page 98

Installation/mounting
5.4 Mounting the SIMOTION panel front
Procedure
1. Follow the installation instructions.
2. Drill suitable holes at the prepared mounting cut-out in accordance with the specifications
3. Carefully drill the respective holes into the control unit in the designated location ① from
1
1
Figure 5-6
4. Working from the front, insert the device into the mounting cut-out.
5. Secure the control unit by inserting suitable screws through the holes and attaching nuts
Note
The mounting depth increases by 21 mm when an optical drive is installed in the device.
Take the dimensions from the dimensional drawings.
See also
Mounting dimensions for SIMOTION P012T (Page 118)
Mounting dimensions for SIMOTION P015T (Page 119)
98
for L4 and L5, as shown in the mounting cut-out in the dimension diagrams.
the rear.
CAUTION
Ensure that no metal cuttings enter the device. Cover the device with film or when
drilling, use removal by suction.
Designated location for holes on the control unit
(torque 0.4 ... 0.5 Nm).
1
1
SIMOTION P350-3 and Panels
Manual, 05/2009