Table of Contents
Advertisement
Application planning
4.1 Overview of application planning
General information about operation
CAUTION
The device is approved for operation in closed rooms only. The guarantee is void if this
stipulation is ignored.
Condensation
When transporting the device at low temperatures, ensure that no moisture gets on or into
the device. This also applies if the device is subjected to extreme changes in temperature.
Commissioning
Allow the device to slowly adjust to room temperature before commissioning the device. Do
not place the device near heat radiation. If condensation develops, wait 12 hours before
you switch on the device.
Vibration
DVD drives are sensitive to vibration. Inadmissible vibration during operation may result in
loss of data or damage to the drive or data medium.
Before transporting the device, wait at least 20 seconds following power off to allow the
drive to stop completely.
Avoid extreme environmental operating conditions. Protect your device against dust,
moisture and heat. For additional information, refer to the technical data.
Do not place the device in direct sunlight.
Chemical resistance
CAUTION
Adhere to the information regarding chemical resistance. Please refer to the information
available online at Address
(http://support.automation.siemens.com/WW/view/en/16532108).
Sources of light
NOTICE
Position the screen so that it is not subject to direct sunlight or other strong sources of light.
78
SIMOTION P350-3 and Panels
Manual, 05/2009
Advertisement
Table of Contents
