Accessories; Wall And Device Support - Atmos E 341 Operating Instructions Manual

8.0 Accessories

Accessories
Serres
DDS canister system 1 l, complete
Wall and device support for ATMOS
Retrofi t kit DDS canister system
Retrofi t kit Serres

8.1 Wall and device support

Affi x the power supply and recharging unit
Prerequisite: The velcro fastener
Damaged cable due to incorrect mounting.
1. Please ensure that the power supply and recharging unit are positioned with the
writing towards the wall or the standard rail. Otherwise the cable could be clamped.
2. Affi x the parts
Wall mounting
Only affi x the power supply and recharging unit after you have marked the holes to be

drilled.
Screws are not included in delivery.

1. Only use screws, which are suitable for the material of the wall.
2. Position the wall and device support at an easily accessible place.
3. Check whether the wall is smooth and vertical at the mounting position.
4. Hold the wall and device support to the mounting location and align it with a spirit
level.
5. Mark the holes to be drilled on the wall.
6. Drill the holes with a drill Ø 3 mm.
7. Mount the power supply and recharging unit to the wall and device support. The
power supply and recharging unit must not be connected to the mains supply.
8. Screw the wall and device support to the wall with suitable screws.
9. Connect the power supply and recharging unit to the mains supply.
10. Check whether the charging accessory is correctly attached by installing the device.
The battery will be charged.
»
46 Accessories
external canister 1 l
®
canister system
®
and and fi x the cable
2 3
2
3
1
emergency suction devices
®
is attached to the wall and device support.
1
with the velcro fastener
4
4
REF
312.0465.0
318.1000.0
318.1250.0
318.1350.0
318.1450.0
.
1