Verifying The Installation - Cisco SCE8000 GBE Installation And Configuration Manual

Chapter 9 Removal and Replacement Procedures

Verifying the Installation

Use the show version command to verify that the system software and firmware are installed properly.
From the SCE> prompt, type show version and press Enter.
Step 1
This example shows the output of the show version command:
SCE8000#>show version
System version: Version 3.5.5 Build 253
Build time: Jun
Software version is: Version 3.5.5 Build 253
Cryptography class: K9
Hardware information is:
---------------------
Firmware
---------------------
kernel
u-boot
select
---------------------
Slot 1: SCE8000-SCM-E
---------------------
serial-num
part-num
cpld
vtpld
summit-0
summit-1
dpt/tx
cls/ff
cls cam
cls flow cap: 33554432
ssa
---------------------
TVR
---------------------
#cpus
cpu SVR
cpu PVR
cpu freq
cpu (eeprom): 2.1, 1000MHz
cpld
cpld-ufm
summit
cf
FwRev=0x242-0230, Size=4125744KB
phy-0
phy-1
phy-2
---------------------
CFC-0
---------------------
board type
#cpus
cpu-0 SVR
cpu-0 PVR
cpu-0 freq
cpu-1 SVR
cpu-1 PVR
cpu-1 freq
cpu-2 SVR
OL-19897-02
2 2009, 17:48:38 (Change-list 484251)
: [kernel] 2.3.0/1 (inactive: [kernel] 2.3.0/1)
: [uboot] 2.1.0/1 (field: [uboot] 0.8.1/18)
: [ubs-cf1] 2.3.0/1 (secondary: [ubs-cf1] 2.3.0/1)
: CAT1231G03R
: 73-10598-01
: 0x816c
: 0xc003
: 0xf2c1001
: 0xf2c1101
: 0x4913
: 0x2112
: 0x454120
: 0x90
: 1
: 0x80900121
: 0x80040202
: 1000MHz
: 0xa1bb
: 0xa803
: 0xf2c1701
: Model=SILICONSYSTEMS INC 4GB-3213, S/N=B8243186VCK20914MX01,
: 0xcc2
: 0xcc2
: 0xcc2
: P2
: 3
: 0x80900121
: 0x80040202
: 1500MHz
: 0x80900121
: 0x80040202
: 1500MHz
: 0x80900121
Cisco SCE8000 GBE Installation and Configuration Guide
Removing and Replacing Modules
9-21