Preparing For Installation; Safety; Site Requirements - Cisco SCE8000 GBE Installation And Configuration Manual

Hide thumbs Also See for SCE8000 GBE:
Table of Contents

Advertisement

Preparing for Installation

Because invisible laser radiation may be emitted from the aperture of the port when no cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures.
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Preparing for Installation

Safety

Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Warning
Read the installation instructions before connecting the system to the power source.
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations.

Site Requirements

This section provides site power requirements for the Cisco SCE8000 GBE chassis. You should verify
the site power prior to installation.
Cisco SCE8000 GBE Installation and Configuration Guide
4-2
Preparing for Installation, page 4-2
Installing the Cisco SCE8000 GBE Chassis in the Rack, page 4-14
Connecting the System Ground, page 4-20
Installing the Power Supplies in the Cisco SCE8000 GBE Chassis, page 4-21
Safety, page 4-2
Site Requirements, page 4-2
Power Connection Guidelines, page 4-4
Preventing Electrostatic Discharge Damage, page 4-3
Environmental Requirements, page 4-3
Power Requirements, page 4-4
Chapter 4
Installing the Cisco SCE8000 GBE Chassis
OL-19897-02

Advertisement

Table of Contents
loading

Table of Contents