Cisco SCE8000 GBE Installation And Configuration Manual page 168

Basic Post-Installation Checklist
To check this: Use this command:
connection mode show interface linecard
connection-mode
link mode show interface linecard link mode
external bypass show interface linecard
configuration external-bypass
RDR formatter show RDR-formatter
connection to
show interface linecard subscriber
sm-connection-failure
Subscriber Manager
connection to Quota show ip rpc-adapter sessions
Manager
Complete command sequence for a fully-populated SCE8000 GBE platform using both the SM and the QM
SCE>enable 5
Password:<cisco>
SCE>show version
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>show interface linecard 0 subscriber sm-connection-failure
SCE>
Cisco SCE8000 GBE Installation and Configuration Guide
A-2
show inventory
show interface GigabitEthernet 3/0/0
show interface GigabitEthernet 3/0/1
show interface GigabitEthernet 3/0/2
show interface GigabitEthernet 3/03
show interface GigabitEthernet 3/0/4
show interface GigabitEthernet 3/0/5
show interface GigabitEthernet 3/0/6
show interface GigabitEthernet 3/0/7
show interface GigabitEthernet 3/1/0
show interface GigabitEthernet 3/1/1
show interface GigabitEthernet 3/1/2
show interface GigabitEthernet 3/1/3
show interface GigabitEthernet 3/1/4
show interface GigabitEthernet 3/1/5
show interface GigabitEthernet 3/1/6
show interface GigabitEthernet 3/1/7
show system operation-status
show interface linecard 0
show interface linecard 0 connection-mode
show interface linecard 0 link mode
show interface linecard 0 external-bypass
show rdr-formatter
show ip rpc-adapter sessions
Appendix A CLI Commands to Verify a Successful Installation
Comments
Make sure that both the connection mode and the failure mode
are configured correctly.
When connection-mode is inline, link mode should be
configured to forwarding.
Only if external bypass modules are installed: Check the
following:
Configuration should be activated on failure
•
The number of devices should match the number of links
•
Verify the following:
The RDR formatter has established a connection with the
•
configured destinations
The redundancy status is configured correctly in case of
•
more then one destination.
If using SM: Verify that the connection with the SM is
established.
If using QM: Verify that the connection with the QM is
established.
OL-19897-02