What To Do Next; Final Tests; Verifying Operational Status; Viewing The User Log Counters - Cisco SCE8000 GBE Installation And Configuration Manual

Chapter 7 Basic Cisco SCE8000 GBE Platform Operations
During the boot process, observe the following LEDs on the SCE8000-SCM-E:
Step 4
•
•
•
It takes a several minutes for the Cisco SCE8000 GBE to boot and for the status LED to change from
Note
amber to green.

What to Do Next

If the system does not complete each of the steps in the startup procedure, proceed to
Problems, page 8-7

Final Tests

The procedures for performing the final tests to verify that the Cisco SCE8000 GBE is functioning
properly are explained in the following sections:
•
•
•
•

Verifying Operational Status

After all the ports are connected, verify that the Cisco SCE8000 GBE is not in a Warning state.
On the front panel of the Service Control module, examine the Status LED; it should be green.
Step 1
To display the operation status of the system, at the SCE# prompt, type show system operation-status
Step 2
and press Enter.
A message displaying the operation status of the system appears. If the system is operating in order, the
following message appears:
System Operation status is Operational.
If the Status LED is red or flashing amber, the following message appears:
System Operation status is Warning
Description:
1. Power Supply problem
2. Line feed problem
3. Amount of External bypass devices detected is lower than expected amount
OL-19897-02
The Power LEDs should be green.
Optical Bypass LED should be green while the Cisco SCE8000 GBE is in bypass and unlit when
the optical bypass is turned off.
The Status LED should be a constant amber while booting. After a successful boot, the Status LED
is steady green.
for troubleshooting recommendations and procedures.
Verifying Operational Status, page 7-3
Viewing the User Log Counters, page 7-4
Viewing the Gigabit Ethernet Port Status, page 7-4
Viewing the Gigabit Ethernet Counters, page 7-4
Starting the Cisco SCE8000 GBE Platform
Cisco SCE8000 GBE Installation and Configuration Guide
Identifying Startup
7-3