Cisco SCE8000 GBE Installation And Configuration Manual page 169

Appendix A CLI Commands to Verify a Successful Installation
CLI Command Output Samples
The text in bold in the following output samples indicates the lines you should check when doing a
post-installation check. For some commands, the output is short and the entire output is relevant. In these
cases, nothing is in bold.
show version
Look for the following lines:
•
•
•
SCE>show version
System version: Version 3.5.5 Build 252
Build time: May 31 2009, 15:50:44 (Change-list 483168)
Software version is: Version 3.5.5 Build 252
Cryptography class: K9
Hardware information is:
---------------------
Firmware
---------------------
kernel
u-boot
select
---------------------
Slot 1: SCE8000-SCM-E
---------------------
serial-num
part-num
cpld
vtpld
summit-0
summit-1
dpt/tx
cls/ff
cls cam
cls flow cap: 33554432
ssa
---------------------
TVR
---------------------
#cpus
cpu SVR
cpu PVR
cpu freq
cpu (eeprom): 2.1, 1000MHz
cpld
cpld-ufm
summit
cf
phy-0
phy-1
phy-2
OL-19897-02
System version
Application file
Management agent interface version
: [kernel] 2.3.0/1 (inactive: [kernel] 2.3.0/1)
: [uboot] 2.1.0/1 (field: [uboot] 0.8.1/13)
: [ubs-cf0] 2.3.0/1 (secondary: [ubs-cf0] 2.3.0/1)
: CAT1151G012
: 73-10598-01 36
: 0x816c
: 0xc004
: 0xf2c1001
: 0xf2c1101
: 0x4913
: 0x2112
: 0x454120
: 0x90
: 1
: 0x80900121
: 0x80040202
: 1000MHz
: 0xa1bc
: 0xa803
: 0xf2c1701
: Model=SMART CF, S/N=20080213025D41EC41EC, FwRev=0x20060811, Size=4062240KB
: 0xcc2
: 0xcc2
: 0xcc2
Cisco SCE8000 GBE Installation and Configuration Guide
Basic Post-Installation Checklist
A-3