Optical Bypass Module Specifications - Cisco SCE8000 GBE Installation And Configuration Manual

The Cisco SCE8000 GBE Optical Bypass
Table 2-9
Port
GBE Line port 8
CTRL
Table 2-10
LEDs
L1/L2

Optical Bypass Module Specifications

Fiber Cable Type
The fiber cable type within the Optical Bypass Module area as follows:
•
•
Maximum optical path (fiber length of two ports) is 600m.
Switching Time
Switching time is measured from trigger to stable 90% optical output.
•
•
Cisco SCE8000 GBE Installation and Configuration Guide
2-12
Optical Bypass Module Ports
Quantity
1
Optical Bypass Module LEDs
Description
The L1 and L2 LEDs indicate the operational status of the optical bypass for
the relevant traffic link as follows:
•
•
OPB-SCE8K-2L-MM: 50 micron Multi-Mode Fiber (MMF).
OPB-SCE8K-2L-SM: SMF-28
Typical switching time: 3 ms
Maximal switching time: 10ms
Chapter 2
Description
GBE ports A1 through D1 and
A2 through D2
Duplex LC, panel mount adaptor
for LC/UPC connectors
RJ-11 port
Green — Bypass module on the link has been de-activated (traffic flows
through the Cisco SCE8000 GBE platform)
Off — Bypass module on the link is active (traffic does not flow through
the Cisco SCE8000 GBE platform)
Introduction to the Cisco SCE8000 GBE Platform
Connect This Port To...
SPA interfaces on the Cisco
SCE8000 GBE .
Refer to Cabling the Line
Interface Ports: Using the
External Optical Bypass
Module, page 6-9 for further
information.
RJ-11 Optical Bypass port on the
SCE8000-SCM-E
OL-19897-02