Maintenance - ESAB Mig 4004 iMV User Manual And Spare Parts

5.3 MIG/MAG operation
1) C onnected Origo 4004 iMV
2) C onnected the wire feeder
the wire feeder to see this User's Manual.
3) Set the I/O switch to the I position. The pilot led lights.
4) Select the MIG process.
5) Select the desired percentage of inductance.
6 Pre-set the welding current throught the potentiometer or the remote control, pre-set )
the wire speed and the gas flow.
7) Start by pressing the torch trigger and adjust the parameters if necessary.
5.4 TIG operation
1) C onnected Origo 4004 iMV
2) C onnected the TIG torch
TIG torch to see this User's Manual.
3) Set the I/O switch to the I position. The pilot led lights.
4) Select the TIG process.
5) Pre-set the welding current throught the potentiometer or the remote control.
6) Touch the tungsten electrode in the part to be welded, press the trigger and lift the
torch to establish the arc and readjust the current if necessary.
P.S.: The parameter welding values depends, basically, on the material and the
diameter of electrode used, the thickness to be weld and the welding position.
6

MAINTENANCE

Regular maintenance is important for the safe and reliable operation.
The maintenance should be done by a professional trained and qualified.
Note!
All guarantee undertakings from the supplier cease to apply if the customer himself
attempts any work in the product during the guarantee period in order o rectify any
faults.
WARNING
to the main power supply
and the work clamp
to the main power supply
and the work clamp
Inspection, troubleshooting, and repair of this equipment should be
undertaken by a competent individual having at least general
experience in the maintenance and repair of semi-conductor
electronic equipment.
undertaken by anyone not having such qualifications.
.
cable Warning: to install and operate .
.
cable Warning: to install and operate the .
Maintenance or repair should not be
- 40 -