Programming With Limit Setting Tool - Screen Innovations Solo Installation Instructions Manual

PROGRAMMING AC(110v) 485 -
WITH LIMIT SETTING TOOL
Setting the Drop:
Solo/Pro 2 is factory preset to have 1" of drop, the
distance between the top of the viewing area and the
cassette. The drop can be adjusted up to the MAX
DROP (see model number or order information for
your screen's MAX DROP) to customize the viewing
surface's vertical position.
NOTE: If a simplified system without a SIFI is setup
then changes to factory settings require a special 485
Setting Tool available from Screen Innovations and
ordered separately (Part # 9017142).
Programming AC(110v) 485 - with Limit Setting Tool
The tool may be used up to 100 ft. away when used with
18GA. copper control wire. To adjust the drop, do the
following:
1. Make sure 110v AC power is supplied to the screen.
2. Use a standard CAT 5e cable to plug in the limit
setting tool to the data hub. Disconnect all devices
that you do NOT want to program (only connect the
device you want to program. Limit setting tool
should be connected to data hub).
3. If you are not using a data hub then you can connect
directly to the screen. Terminate the cable as directed
in the 485 wiring port chart (refer to page 20).
4. Plug the RJ45 into the setting tool.
5. Turn the setting tool on by pressing the ON/OFF
button.
24
Programming AC(110v) 485 - with Limit Setting Tool
25