Setting Up Wired Screen Using Moab - Screen Innovations Solo 3 Installation Instructions Manual

SETTING UP WIRED SCREEN USING MOAB

5. If the screen is wired with wired communication or 485 control, it will include a motor control board,
Moab. This control board allows for setting limits and/or controling the screen. Typically, this board is
located in the head end/equipment location. See the wiring chart on page 11 to determine maximum
wire length.
6. Upper and lower limits are already factory-set. Once all connections are made including the power
supply, you may now adjust the lower limits using the Moab control board.
Setting up Wired Screen Using Moab
DC Wire Diagram Illustrating Inital Setup
LED15 LED15
LED9 LED9
USER PROG USER PROG
LED11 LED11
LED12 LED12
Scan the QR code for complete details on how to install and program using
Moab.
LED13 LED13
LED3 LED3
LED2 LED2
LED7 LED7
LED8 LED8
9