Rts - Running; Rts - Programming - Screen Innovations 5 Motorized Owner's Manual

24V RTS - RUNNING
The RF remote, supplied with the screen, controls the deployment and retraction from up to 30
feet away. Enjoy!
RF controlled projection screens operate at 433.42MHz. Minimize or eliminate any sources of RF
interference and shielding. Any metal, wire, or foliage can reduce or block the signal - reducing
the operating range of the controls. Other nearby transmitters may cause interference also.
1. Connect the power supply - 5 Motorized with an RTS motor is shipped with the remote
already paired to the screen. Plug the power supply into the wall and plug the connectors
together.
2. The screen is ready for operation.
20
24V RTS - PROGRAMMING
Setting the Drop - 5 Motorized is factory preset to have 12'' to 48" of drop, the distance between
the top of the viewing area and the cassette. The drop can be changed to be up to the MAX
DROP (see model number or order information for your screen's max drop) to customize the
viewing surface's vertical position. To adjust the drop, do the following:
1. Press the down button on the RF remote to send the screen to its lower limit and wait until it
stops there. Screen must be at its current lower limit before you can alter it.
2. Hold the UP and DOWN buttons simultaneously until the screen jogs once.
3. Use the DOWN and UP buttons to position the viewing area vertically, up to Max Drop from
the bottom of the cassette.
DO NOT set the lower limit (top of viewing) more than MAX DROP from the cassette.
Doing so risks damaging the screen material.
4. Once the viewing area is positioned, hold the middle square STOP button until the screen
jogs once. This saves the new lower limit. If this Step is not completed, the screen will jog
once after about 3 minutes, indicating that its no longer in program mode, and the motor will
only recall the previous lower limit. No changes will be saved.
12" to 48'' Factory default drop
Drop - Can be set up to MAX DROP
21