Ac(110V) Rts Running; Programming - Screen Innovations Solo Installation Instructions Manual

AC(110v) RTS
RUNNING
Solo/Pro 2 is very easy to operate. The RF remote,
supplied with the screen, controls the opening and
closing from up to 30 feet away. Enjoy!
RF controlled projection screens operate at
433.42MHz. Minimize or eliminate any sources of RF
interference and shielding. Any metal, wire, or foliage
can reduce or block the signal - reducing the operating
range of the controls. Other nearby transmitters may
cause interference also.
1. Turn on AC(110v) power to the screen.
2. Solo/Pro 2 with an RTS motor is shipped with the
remote already paired to the screen. The screen is
ready for operation.
AC(110v) RTS - Running
PROGRAMMING - AC(110v) RTS
Setting the Drop - Solo/Pro 2 is factory preset to have
1" of drop, the distance between the top of the viewing
area and the cassette. The drop can be changed to
be up to the MAX DROP (see model number or order
information for your screen's max drop) to customize
the viewing surface's vertical position. To adjust the
drop, do the following:
1. Press the down button on the RF remote to send the
screen to its lower limit and wait untill it stops there.
Screen must be at its current lower limit before you
can alter it.
2. Hold the UP and DOWN buttons simultaneously until
the screen jogs once.
3. Use the DOWN and UP buttons to position the
viewing area vertically, up to Max Drop from the
bottom of the cassette.
16 AC(110v) RTS - Programming 17