Flatten The Material At The Weight Bar - Screen Innovations Solo Installation Instructions Manual

9. Slide the cassette left to right to verify it is
positioned at your desired viewing location, then
lock the screen in place, rotating the wall bracket
lever to the upward position.
10. Remove the weight bar screw before deploying
screen (see red label on the weight bar)
11. Use your preferred control method to deploy the
screen material and remove the weight bar
shipping locks.
Solo/Pro 2 - Installation
FLATTEN THE MATERIAL AT
THE WEIGHT BAR
Follow these steps:
1. Bump the bottom of the weight bar up several
times along it.
2. Use 2 fingers to pinch the material just above the
middle of the weight bar and lightly pull on the
material to smooth out any wrinkles at the weight bar.
3. Repeat the process to move the material from the
center toward the other edge.
4. If the screen has been
stored in a wrinkled
condition. The wrinkles
may not fall out
immediately. If wrinkles
remain after an hour, call
512.832.6939 (opt.1) for
further instructions.
14

Flatten the Material at the Weight bar

15