Pairing Another Rf Remote; Rs485 Programming With Sifi - Screen Innovations Solo/Pro 2 Installation Instructions Manual

PAIRING ANOTHER RF REMOTE

USING ORIGINAL REMOTE
If another remote was purchased, it will not come
paired to your screen motor. To pair it, first take the
working remote supplied with the Solo/Pro 2 and press
the Program button on the back of the remote until
the screen jogs once. Holding the new remote, briefly
press* the Program button on the back. The screen
will jog once. The new remote is now paired with the
screen.
Long Press
Original Remote
*A brief press is about ½ second long. Too short or too long of
a button press may not perform the desired operation.
Pairing another RF remote
Brief Press
New Remote
20
24V RS485
PROGRAMMING WITH SIFI
RS485 screens are most commonly used with the SIFI
controller. The screens are fully commissioned via
the SIFI web interface. Only after fully commisioning
your screen should you then use your control system's
programming guide to integrate your screen into it.
RS485 Wiring Pinout
Utilizing RJ-45 TIA-568B termination standard
Pin# Color
1 Orange White
2 Orange
3 Green White
4 Blue
5 Blue White
6 Green
7 Brown White
8 Brown
RJ45
For Screen Data, use Pins 1,2 & 8
Programming 24v RS485 - with SIFI
Function
SDN RS485 (+)
SDN RS485 (-)
Reserved
Power 24v DC
Power 24v DC
Reserved
SDN RS485 Ground
SDN RS485 Ground
(cont. on next pg)
21