Section 3: Service Procedures; Maintenance Procedures - Thermo Scientific PARTISOL 2000 Service Manual

Service Manual, Partisol Model 2000 Air Sampler
S 3: S P
ECTION ERVICE ROCEDURES

Section 3: Service Procedures

This section describes the service procedures required to maintain consistent opera-
tion of the Partisol Sampler. Additional maintenance procedures (such as cleaning the
PM-10 inlet) are contained in the Operating Manual. This section provides recom-
mended intervals for maintenance and calibration procedures. However, when
determining your own intervals for maintenance and calibration, you must take into
account the quality assurance guidelines of your specific monitoring organization and
any special local considerations.

Maintenance Procedures

Exchange large in-line filter
Exchange fuses
Clean air intake filters
Inspect "V" seals
System leak test
Test batteries
Rebuild vacuum pump
Calibration Procedures
Interface board calibration
Analog input calibration
Ambient air temperature calibration
Ambient pressure calibration
Mass flow controller calibration
3.1. M
AINTENANCE
This section contains maintenance procedures for the Partisol Sampler. Additional
maintenance procedures (such as cleaning the PM-10 inlet) are contained in the
Operating Manual.
3.1.1. E
XCHANGING THE
The large in-line filter prevents particulate matter from entering the sampler's flow
controller and causing damage.
Tools Needed: Phillips screwdriver
Materials:
Interval
6 months
As needed
6 months
during filter exchange Section 3.1.4
3 months
6 months
18 months
Interval
1 year
1 year
1 year
1 year
1 year
P
ROCEDURES
L I -L F
ARGE N INE ILTER
Needle nose pliers
Large in-line filter (R&P P/N 32-002643)
Revision B.000
Reference
Section 3.1.1
Section 3.1.2
Section 3.1.3
Section 3.1.5
Section 3.1.6
Rebuild kit
Reference
Section 3.2.1
Section 3.2.2
Section 3.2.3
Section 3.2.4
Section 3.2.5
P 3-1
AGE