Service; Diagnostic And Calibration Procedures - Thermo Scientific Dionex ICS-2000 Operator's Manual

This chapter describes ICS-2000 service and repair procedures that the user can
perform. All procedures not included here, including electronics-related repair
procedures, must be performed by Dionex personnel. For assistance, contact
Dionex Technical Support. In the U.S., call 1-800-346-6390. Outside the U.S.,
call the nearest Dionex office.
Before replacing any part, refer to the troubleshooting information in
isolate the cause of the problem.
Substituting non-Dionex parts may impair performance, thereby
voiding the product warranty. Refer to the warranty statement in the
Dionex Terms and Conditions for more information.
5.1

Diagnostic and Calibration Procedures

Diagnostic and calibration procedures can be performed either from the touch
screen or from the Chromeleon Wellness Panel (see
For an overview of the Wellness Panel features, see
overview of the diagnostic and calibration touch screen, see
instructions on performing calibration and diagnostic procedures, see the
following sections:
•
Calibrating the Conductivity Cell
•
Calibrating the Flow Rate
•
Calibrating the Vacuum Degas Assembly
Doc. 031857-03 4/06
(Section 5.1.3)
(Section 5.1.4)
(Section
5 • Service
Chapter 4
Figure 5-1).
Section 5.1.1. For an
Section 5.1.2. For
5.1.5)
to
5-1