8. If the Wizard has successfully installed the drivers for all of the
displays supported by your BarcoMed Display Controller(s), the
Wizard will advise you that the installation is complete and prompt
you to click "Finish"
installing the display drivers and return to the BarcoMed Product
Install Wizard. Clicking "Cancel"
BarcoMed Product Install Wizard, but will not delete the Barco
Display Drivers.
If the Wizard failed to successfully install the drivers for all of the
displays supported by your BarcoMed Display Controller(s), the
Wizard will advise you that the installation failed (see figure 15 on
the next page). Click "Finish"
to return to the BarcoMed Product Install Wizard.
After returning to the BarcoMed Product Install Wizard Welcome
Screen, the wizard will automatically begin installing the next
selected piece of BarcoMed Software. If you are working with the
default selections, this will be the BARCO DPMS InstallShield
System manual Coronis 5MP
Figure 13
"Finish"
"Finish" (see figure 14). Click "Finish"
"Finish"
"Finish"
"Cancel" will also return you to the
"Cancel"
"Cancel"
"Cancel"
Figure 14
"Finish"
"Finish"
"Finish" to exit the Driver Install Wizard and
"Finish"
BarcoMed software driver installation
"Finish" to finish
"Finish"
"Finish"
"Finish"
52