Portrait Or Landscape Position; Connecting The Signals - Barco Coronis 5MP System Manual

Portrait or landscape position

Portrait or landscape position
Portrait or landscape position Portrait or landscape position Portrait or landscape position
You can change the orientation of the panel at any time, but it is more
convenient to select landscape or portrait orientation before connect-
ing the cables.
T T T T T o change the p o change the panel orient o change the p o change the p
o change the p
1 Stand at the front side of the panel and take the panel at both
sides.
2 Very important: T T T T T ilt the p
Should you change the panel orientation without tilting it first, you
might irreversibly damage the tilt & swivel mechanism.
3 To change from portrait to landscape, turn the panel
counterclockwise while tilting it slightly.
To change from landscape to portrait, turn clockwise.

Connecting the signals

Connecting the signals
Connecting the signals
Connecting the signals Connecting the signals
To get access to the connectors, open the cover of the connector
compartment by pulling down the 2 clips of the cover.
The signal cables can be routed inside the display foot. Therefore,
remove the foot cover before connecting the signals (see § 2.2 ).
T T T T T o connect DVI signals: o connect DVI signals: o connect DVI signals: o connect DVI signals:
o connect DVI signals:
1 Connect one end of the DVI cable to the DVI input (5) of the
display.
2 Connect the other end of the DVI cable to the video output of your
DVI signal source.
3 Route the cable so that it enters the connector compartment at the
place where the cover is bulged.
System manual Coronis 5MP
anel orientation: anel orient anel orient ation: ation: ation:
anel orient ation:
ilt the p ilt the panel before changing the orient ilt the p anel before changing the orientation. anel before changing the orient anel before changing the orient
ilt the p anel before changing the orient
Display installation
ation. ation. ation.
ation.
28