Belling Db4 90dft Prof Manual page 33

Fitting the plinth (if applicable)
Make sure the appliance is raised to a height of 915mm
G
or above before beginning. If the appliance is below
915mm - you can only fit the plinth cover labelled X.
You can adjust the height using the feet (1) of the
appliance.
If your appliance has a storage drawer at the bottom,
you access the required holes through the base of the
drawer after lifting the mat.
Open the appliance doors, and loosen screw A located
G
on bracket (2). Do not remove this screw entirely.
Insert screw B, through slot (3) and screw into the small
G
hole at the bottom of bracket (2).
Make sure that the plinth cover is flush to the appliance,
but not over tightened.
Fitting the splashback (if applicable)
Remove the screws from the rear of the hotplate vent.
G
Locate the splashback in position so that all the fixing
G
holes are in line with the holes in the rear of the hot-
plate vent.
Re-fit screws into the holes to secure the splashback in
G
place.
Installing Your Cooker
Oven cavity
Door
(1)
X
B
Y
Plinth cover
A
(2)
(3)