Belling Db4 90dft Prof Manual page 34

Stabilising and Securing
Your cooker may come with a stability chain, if it does not
we recommend that you buy a stability bracket from your
local supplier, this will keep the cooker from moving and
will prevent damage to the flexible hosing at the back of
the cooker.
Your cooker must be secured to a wall or a solid partition
behind the cooker.
Your stability bracket
You can buy a stability bracket from your supplier and it
can fitted as follows:
Place the cooker in position and draw a pencil line level
G
with the front edge.
Remove the cooker and mark off 450mm from the
G
pencil line to locate the front edge of the lower
bracket.
Fix the bracket to the floor. Measure from floor level
G
to engagement edge in the back of the cooker and add
3mm.
Assemble the underside of the top part of the bracket
G
to this height.
See the drawings for the location of the bracket and
G
the recommended positioning.
Once your cooker is secure:
Place a spirit level onto a baking tray, on an oven shelf.
These cookers are fitted with adjustable feet which will
allow you to adjust the height of the appliance until it is
level. The adjustable feet are at the rear of the cooker.
X
Locate stability bracket here
Model viewed from rear
Installing Your Cooker
Your stability chain
Levelling
Rear
plinths
Stability Hook
(not supplied)
Stability chain to
be as short as
possible
Cooker stability chain not designed
with bracket engagement slot
g
Rear of cooker
Firmly fix chain
to cooker rear