Using The Clock / Programmer - Belling Db4 90dft Prof Manual

Using The Programmer/Clock
Through your programmer you will be able to set the time
of day, set the minute minder, and use the semi and fully
automatic cooking functions. The programmer is vital to
the working of your appliance, and reading this section will
make sure that you get the most out of your ovens.
The programmer buttons (push button timer)
There are three buttons on this type of timer. The table
below shows you what their symbols look like, depending on
the model type, and what they do.
Symbol Symbol
-
+
Setting the time of day (push button timer)
Press the Plus and Minus buttons together for a few
G
seconds, and release.
The ' ' in between the numbers on the LED Display will
G G
begin to flash.
While the ' ' is flashing it is possible to adjust the time
G G
using the Plus and Minus buttons.
Important - Once
G
approximately 30 seconds before using any of
the other timer functions. This ensures that the time
will remain correct.
Wait until the clock has finished flashing before attempt-
ing to use other functions of the clock
What is it?
Down / Minus
Used to decrease cook / end time, remove
minutes from the minute minder and adjust
the time of day.
Also for listening to and setting the alarm
tone. There are 3 tones to choose from.
Up / Plus
Used to increase cook / end time, add minutes
to the minute minder and adjust the time of
day.
Function button
Used to select the functions available on this
timer.
Press once for: Minute Minder.
Press twice for: Cook time
Press three times for: End time.
How to use these functions is explained later
on in this section.
the time has been set, allow
What your timer symbols
mean.
Automatic
Cook Pot
symbol
This is a 24 hour clock.
i
Before you do anything
with your appliance -
you must set the cor-
rect time of day.
Minute Minder
symbol