Belling Db4 90dft Prof Manual page 11

Using The Programmer/Clock
The programmer Icons (touch control timer)
There are three icons on this type of timer. The table below
shows you what the symbols look like, depending on the
model type, and their functions.
Note - some functions require you to 'touch and hold'
an icon for a few seconds, whilst others require you
just to 'touch' the icon without holding it.
Symbol Symbol
-
+
Setting the time of day (touch control timer)
Touch and hold the centre icon for a few seconds and
G
release.
The ' ' in between the numbers on the LED Display will
G G
begin to flash.
While the ' ' is flashing you can adjust the time using the
G G
Plus and Minus icons.
Please note: the hours and minutes adjust quickly
Important - Once
G
approximately 30 seconds before using any of
the other timer functions. This ensures that the
time will remain correct.
Setting an alarm tone (touch control timer)
Touch and hold the Plus and Minus icons simultaneous-
G
ly until the ' ' flashes and you hear a beep.Then press
G
the centre icon.
Touch the minus icon to select the tone.
G
You can change the tone by repeatedly touching the
G
minus icon (3 tones)
What is it?
Down / Minus
Used to decrease cook / end time, remove
minutes from the minute minder and adjust
the time of day.
Also for listening to and setting the alarm
tone. There are 3 tones to choose from.
Up / Plus
Used to increase cook / end time, add minutes
to the minute minder and adjust the time of
day.
Function icon
Used to select the functions available on this
timer.
Press once for: Minute Minder and to set
the time of day.
Press twice for: Cook time
Press three times for: End time.
How to use these functions is explained later
on in this section.
the time has been set, allow
What your timer symbols
mean.
Automatic
Cook Pot
symbol
Minute Minder
symbol