Memory Management; How To Enter Memory Process; Delete Memory - Chroma 19572 User Manual

System parameter setting description table
Setting Item
Contrast
1∼16
Beeper Vol. LOW / MEDIUM /
HIGH / OFF
0, 0.1 ∼ 99.9 s
Pass ON
(0: CONT.)
4.5

Memory Management

4.5.1 How to Enter Memory Process

1. In power on menu, press Function Key [MENU] to display the menu below:
1. MEMORY
2. SYSTEM
3. OPTION
4. CALIBRATION
5. KEY LOCK
SELECT FUNC.
2. Move the highlight to "Memory" by using Function Key [UP], [DOWN]. Press
Function Key [SELECT] to enter Memory management mode and is shown as below
menu.
1. ( 0 )
2. ( 0 )
3. ( 0 )
4. ( 0 )
5. ( 0 )
SELECT FUNC.
3. At the same time, follows the instruction of Function Key can recall, store or delete this
memory.
4. The value in ( ) means the test step numbers included in the memory.

4.5.2 Delete Memory

If you want to delete the test parameter stored in the memory. Please follow the procedures
below to process.
1. When the status list shows "SELECT FUNC.", press Function Key [DELETE].
2. By using Function Key [UP], [DOWN] to select the test parameter data of the memory
Range Initial Setting
7
HIGH
CONT.
RMT LOCK
RMT LOCK
Description
Adjust LCD brightness
Adjust buzzer volume
When test result is PASS,
sets the time of "Pass
Relay ON" on rear panel.
UP
DOWN
SELECT
EXIT
OFST ERR
STORE
RECALL
DELETE
EXIT
OFST ERR
Panel Description
4-5