3.3.1.2
USB DOM
You need:
a PH2 screw driver
a standard USB DOM
the USB DOM mounting screw (included in the unit)
An USB DOM compliant module can be installed at location M6:
1.
Make sure the USB DOM is compliant with the socket.
2.
Insert the DOM onto the header from the top. Make sure the header and recep-
tacle align properly as shown below
3.
If properly inserted. The mount hole in the DOM and the threaded insert will be
aligned. Insert the DOM mounting screw and tighten it.
FWA-1320 User Manual
Figure 3.22 USB DOM mounting screw
Figure 3.23 USB DOM site with header & standoff
Figure 3.24 USB DOM alignment
56