Honeywell SmartVFD HVAC2 Applications Manual page 178

Table 58. Input process data
Modbus
ID register
32008, Programmable
2008
42008 by P9.9
32009,
2009 -
42009
32010,
2010 -
42010
32011,
2011 -
42011
NOTE: 2004 - 2007 can set as PID Control Ref-
erence by setting P14.1(Setpoint selec-
tion) or PID Actual value by setting
P14.4(Feedback value selection)!
NOTE: 2004 - 2007 can be set as the Analogue
Output by P8.1, P8.5, P8.9.
NOTE: 2004 - 2008 can set as Aux Control Word
with P9.9:
b0: Run enable
b1: acc / dec ramp 2 selection
b2: freq reference 2 selection
Name Scale
- -
- -
- -
NOTE: - AUX CW is active when configured, even
if control place is not the fieldbus
- b0 Run enable is computed in AND with
Type
a possible Run enable signal from digital
input. Fall of enable will cause coasting
stop.
Status word (output process data)
Information about the status of the device and
messages is indicated in the Status word. The
Status word is composed of 16 bits the meanings
of which are described in the table below:
Table 59. Status word (output process data)
Bit
B0, RDY
B1, RUN
B2, DIR
B3, FLT
178
Description
Value = 0
Drive not Drive ready
ready
Stop Run
Clockwise Counter-clockwise
No fault Fault active
Value = 1
31-00108—07