Ext 1 & Ext 2; Lf Out; Sweep Out; Pulse - Keysight Technologies X Series User Manual

2. EXT 1 & EXT 2
Connector female BNC
Signal An externally supplied ±1 V
Damage Levels 5 V and 10 V
rms

3. LF OUT

Connector female BNC
Signal Voltage range: 0 to +5 V
Offset: -5 V to +5 V, nominal
For more information, see page

4. SWEEP OUT

Connector female BNC
Can drive 2 kΩ.
Signal Voltage range: 0 to +10 V, regardless of sweep width
In swept mode: beginning of sweep = 0 V; end of sweep = +10 V
In CW mode: no output
This is a multiple use connector. For signal routing selections, see pages

5. PULSE

Connector female BNC
Signal Externally supplied: +1 V = on; 0 V = off
This can also serve as a burst envelope input: 0V = 100% amplitude, –1.00V = 0% amplitude
Damage Levels ≤ −0.3 and ≥+5.3 V
6. TRIG 1 & 2
Connector female BNC
Signal An externally supplied TTL or CMOS signal for triggering operations, such as point to point in
manual sweep mode or an LF sweep in external sweep mode.
Triggering can occur on either the positive or negative edge.
Damage Levels ≤ −0.5 and ≥+5.5 V

7. REF IN

Connector female BNC
Signal An externally supplied −3.5 to +20 dBm signal from a timebase reference that is within ±1 ppm.
In its factory default mode, the signal generator can detect a valid reference signal at this
connector and automatically switch from internal to external reference operation.
See "Returning to a Known State with the Preset Key" on page
reference input), you must explicitly tell the signal generator the external reference frequency you
wish to use; enter the information through the front panel or over the remote interface.
Keysight EXG and MXG X-Series Signal Generators User's Guide
Impedance nominally 50 Ω
signal that produces the indicated depth.
p
p
Impedance 50 Ω
p
.
137
Impedance <1 Ω
Impedance nominally 50 Ω
Impedance high Z
Impedance nominally 50 Ω
Models, Options, and Front/Rear Panels for All Models
Rear Panel Overview (N5173B & N5183B)
and
63
56. With Option 1ER (flexible
.
135
33