Operating The N5102A Module In Input Mode; Accessing The N5102A Module User Interface - Keysight Technologies X Series User Manual

Using the N5102A Digital Signal Interface Module for N5172B/82B with Option 003/004 and
653/655/656/657

Operating the N5102A Module in Input Mode

Operating the N5102A Module in Input Mode
This section shows how to set the parameters for the N5102A module using the signal generator UI
in the input direction. Each procedure contains a figure that shows the softkey menu structure for
the interface module function being performed.
Refer to "Connecting the Clock Source and the Device Under Test" on page 431
test setup.

Accessing the N5102A Module User Interface

Figure 17-16 shows the Auxiliary menu that is accessed by pressing the Aux Fctn key on the front
panel of the signal generator.
Figure 17-16 First-Level Softkey Menu
Aux Fctn
All parameters for the N5102A module are set with softkeys on the signal generator.
Press N5102A Interface to access the UI (first-level softkey menu shown in
used to configure the digital signal interface module. Notice the graphic in the signal generator
display, showing a setup where the N5102A module is generating its own internal clock signal. This
graphic changes to reflect the current clock source selection.
Figure 17-17 N5102A Interface Menu
444
Internal clock going to the DUT
Line is grayed out until the N5102A module interface is turned on
Keysight EXG and MXG X-Series Signal Generators User's Guide
and configure the
Select either PXB or N5102A
connectivity.
The default selection is N5102A.
Press here to access the N5102A
menu.
Figure 17-17) that is