Table of Contents
Advertisement
X Internal I/O Connectors
USB Ports
USB 3
USB 9/10
USB 7/8
„ USB 7/8, 9/10 (USB 2.0) Pin Assignment
2
10
1
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
In addition to the rear USB ports as introduced previously in this chapter, the system board is
equipped with five internal USB 2.0 ports as illustrated above. USB 3 can also be a Type A verti-
cal connector by request.
The internal USB pin headers may be connected to a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis and then insert the USB port
cables to a connector.
BIOS Setting
Configure the onboard USB in the Advanced menu ("USB Configuration" submenu) of the BIOS.
Refer to chapter 3 for more information.
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S state(s).
User's Manual | AL102
„ USB 3 (USB 2.0) 5-pin Header
5
1
Internal I/O Connectors
X
Front Panel
„ Front Panel Pin Assignment
Pin
Assignment
1
N.C.
3
HDD Power
HD-LED
5
Signal
7
Ground
RESET
9
Signal
11
N.C.
HDD-LED - Hard Disk Drive LED
Lighting of the LED indicates that the hard drive is being accessed.
RESET - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light up. When the system is in the S1 (POS -
Power On Suspend) state, it will blink at 1-second intervals. When the system is in the S3 (STR
- Suspend To RAM) state, it will blink at 4-second intervals.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
Chapter 2
HARDWARE INSTALLATION
12
11
ATX-SW
RESET
HD-LED
PWR-LED
2 1
„ Front Panel Connector
Pin
Assignment
2
LED Power
PWR-LED
4
LED Power
6
Signal
8
Ground
ATX-SW
10
Signal
12
---
19
Advertisement
Table of Contents
