Table of Contents
Advertisement
Internal I/O Connectors
Expansion Slots
X
X
Please follow the steps below to install the card into the socket.
User's Manual | AL102
Step 1:
Insert the card into the socket at an
angle while making sure the notch
and key are perfectly aligned.
Step 2:
Press the end of the card far from
the socket down until against the
stand-off.
Step 3:
Screw tight the card onto the stand-
off with a screw driver and a stand-
off screw until the gap between
the card and the stand-off closes
up. The card should be lying paral-
lel to the board when it's correctly
mounted.
Internal I/O Connectors
X
Battery
„ Battery
2
GND
1
3.3V
„ Battery Addendum
The lithium ion battery addendum supplies power to the real-time clock and CMOS memory as
an auxiliary source of power when the main power is shut off.
Safety Measures
• There exists explosion hazard if the battery is incorrectly installed.
• Replace only with the same or equivalent type recommended by the manufacturer.
• Dispose of used batteries according to local ordinances.
Chapter 2
HARDWARE INSTALLATION
Connect to board
26
Advertisement
Table of Contents
