DFI AL102 User Manual page 37

Advanced Console Redirection
X X
COM1~COM10 Sub-menu
InsydeH2O Setup Utility
Advanced
COM1
PortEnable <Enabled>
UseGlobalSetting <Enabled>
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
PortEnable
This field is used to enable or disable the COM port to redirect the console.
UseGlobalSetting
This field is to enable or disable to use global settings. When enabled, settings of the COM port
will be subject to those in the Console Redirection syb-menu. When disabled, settings of the
current COM port can be configured regardless of the global settings.
By disabling the UseGlobalSetting field, the following fields for configuring serial aspects will
become available as shown on the right.
User's Manual | AL102
Rev. 5.0
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
InsydeH2O Setup Utility
Advanced
COM1
PortEnable <Enabled>
UseGlobalSetting <Disabled>
Terminal Type <VT_100>
Baud Rate <115200>
Data Bits <8 Bits>
Parity <None>
Stop Bits <1 Bit>
Flow Control <None>
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Terminal Type
Select terminal type: VT_100, VT_100+, VT_UTF8 or PC_ANSI.
Baud Rate
Select baud rate: 115200, 57600, 38400, 19200, 9600, 4800, 2400, or 1200.
Data Bits
Select data bits: 7 bits or 8 bits.
Parity
Select parity bits: none, even or odd.
Stop Bits
Select stop bits: 1 bit or 2 bits.
Flow Control
Select flow control type: none, RTS/CTS or XON/XOFF.
Chapter 3
BIOS SETTING
Rev. 5.0
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
36