DFI AL102 User Manual page 40

X Boot
InsydeH2O Setup Utility
Main Advanced Security Boot Exit
Setup Prompt Timeout [0]
Numlock <Off>
Quiet Boot <Disabled>
Network Stack <Disabled>
PXE Boot capability <Disabled>
USB Boot <Enabled>
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Setup Prompt Timeout
Select the number of seconds that the firmware will wait before booting the original default
boot selection.
Numlock
Select the power-on state for numlock.
Network Stack
This field is used to enable or disable network stacks, i.e. IPv4 or IPv6 network protocols.
Note:
AL102 only supports UEFI boot. Legacy boot is not supported.
User's Manual | AL102
Rev. 5.0
The number of seconds
that the firmware will wait
before booting the original
default boot selection.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
PXE Boot capability
This field is only available when "Network Stack" is enabled.
Disabled Suppoort Network Stack
UEFI IPv4/IPv6
USB Boot
Enable or disable booting to USB boot devices.
Quiet Boot
Enable or disable booting in text mode.
X EFI
Configure boot priorities in this submenu. Press -/+ or F5/F6 to move the highlighted item
down/up the priority list.
InsydeH2O Setup Utility
Boot
EFI
EFI Network 0 for IPv4 (00-00-00-00-00-00)
EFI Network 1 for IPv4 (11-11-11-11-11-11)
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Chapter 3
BIOS SETTING
Rev. 5.0
EFI
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
39