DFI AL102 User Manual page 39

Advanced SIO NUVOTON6116D
X X
Smart Fan Function
InsydeH2O Setup Utility
Advanced
SYS Smart Fan1 Control <Enable>
Boundary 1 [30]
Boundary 2 [40]
Boundary 3 [50]
Boundary 4 [60]
Fan Speed Count 1 [35]
Fan Speed Count 2 [60]
Fan Speed Count 3 [80]
Fan Speed Count 4 [100]
SYS Smart Fan2 Control <Enable>
Boundary 1 [30]
Boundary 2 [40]
Boundary 3 [50]
Boundary 4 [60]
Fan Speed Count 1 [35]
Fan Speed Count 2 [60]
Fan Speed Count 3 [80]
Fan Speed Count 4 [100]
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Smart Fan is a fan speed moderation strategy dependent on the current system temperature.
When the system temperature goes higher than the Boundary setting, the fan speed will be
turned up to the setting of the Fan Speed Count that bears the same index as the Boundary
field.
SYS Smart Fan1/Fan2 Control
Enable or disable the system smart fan. When disabled, fan speed will not be controllable
according to different system temperatures. Instead, a Fix Fan Speed Count field will be dis-
played to configure at which speed the fan will always be fixed regardless of system tempera-
ture.
Boundary 1 to Boundary 4
Set the boundary temperatures that determine the fan speeds accordingly, the value ranging
from 0-127oC. For example, when the system temperature reaches Boundary 1 setting, the fan
speed will be turned up to the designated speed of the Fan Speed Count 1 field.
Fan Speed Count 1 to Fan Speed Count 4
Set the fan speed, the value ranging from 1-100%, 100% being full speed. The fans will operate
according to the specified boundary temperatures above-mentioned.
User's Manual | AL102
Rev. 5.0
Enable/Disable Smart
Fan
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
X Security
InsydeH2O Setup Utility
Security
Current TPM Device <TPM 2.0 (FTPM)>
TPM State All Hierarchies Enabled, UnOwned
TPM Availability <Available>
TPM Operation <No Operation> Boot
Clear TPM [ ]
Supervisor Password Not installed
Set Supervisor Password
T P M Av a i l a b i l i t y
Available
Hidden
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
TPM Availability
Show or hide the TPM availability and its configurations.
TPM Operation
Select one of the supported operation to change TPM2 state.
Clear TPM
Remove all TPM context associated with a specific Owner.
Set Supervisor Password
Set the supervisor's password and the length of the password must be greater than one char-
acter.
Chapter 3
BIOS SETTING
W h e n H i d d e n , d o n ' t e x -
poses TPM to 0
Exit
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
Rev. 5.0
38