Connecting The Air Tubes - JUKI KE-750 Setup Manual

5. Connecting the Air Tubes

Fixing base
Tie-up band
1) Connect the air tube (¿.12), piped at the factory side, to the hand valve.
2) Adjust the pressure adjustment knob to 5 kgf/cm
3) Make sure that the pressure switch is set to 4 kgf/cm
(Use the (-) screw driver to adjust the pressure switch.)
4) Fix the air tube, piped at the factory side, at the fixing base with the tie-up band.
(It should not interfere in the replacement table.)
A view direction drawing
Hand valve
(a) Close
(b) Open
Cover RBR
Cover RBC
Piping at factory side
connect
Hand valve
Fixing base
Pressure switch (Pressure detection cable assembly)
!
Pressure
switch
Pressure
gauge
Pressure
adjustment
knob
2
.
Be sure to use dried air through the
CAUTION
drier to supply compressed air.
- -
8
Cover RBL
2
.