Attaching The Supplied Parts - JUKI KE-750 Setup Manual

7. Attaching Other Supplied Parts
(1) Signal Light
a) Insert the signal light through the upper hole of the cover RUR.
b) Locate the supplied nuts and washers as indicated in Figure 7.2, then fix them on
the bracket.
!
CAUTION
(2) Vision Monitor
a) Insert the power code of the vision monitor from the hole in the middle of the monitor
base to the main unit, then fix the top of the vision monitor on the monitor base.
! CAUTION
b) Pull out the image monitor cable from the rear of the monitor top, then connect it to
the VIDEO IN jack.
c) Connect the power code connector to the power relay cable at the rear side of the
panel computer.
Figure 7.1
Connect the connector to the bracket.
After installing the signal light, adjust its height so that the distance
from the floor to the upper surface of the signal light can be 2,000 mm
(2,050 mm if installing the machine abroad).
Make sure that the protruded part of the monitor top is hooked over
the knob of the monitor base.
Vision
monitor
Signal light
Image monitor cable
Monitor base
Knob
Figure 7.3
- -
10
Cover RUR
Figure 7.2