JUKI KE-750 Setup Manual page 30

Adding the trolley spacer (E2738721000) (For height adjustment)
Adjust the height of the replacement table with the trolley spacer as shown in Figure 11.4 if an
inconvenience occurs due to a slanting floor or a low replacement table.
Trolley
Caster plate
1. Loosen the fixing screws.
2. Insert the M6 screw into the height adjustment tap, then turn the M6 screw until the
space between the caster plate and the trolley is made.
3. Insert the required pieces of the trolley spacer into the space.
4. Remove the adjustment screw, then tighten the fixing screw.
! CAUTION
When the caster plate is fixed at the upper
position, insert the trolley spacer into the
space between the trolley and the fixing
screw, and then fix them as shown in
Figure 11.5.
Height adjustment tap (M6)
Fixing screw
Figure 11.4
Trolley
Fixing screw
- -
27
Trolley spacer
E2738721000
Caster plate
Trolley spacer
Figure 11.5