JUKI KE-750 Setup Manual page 39

(2) How to Pack
a. Packing the Center part
1) Roll up the air cap which is to be crashed easily when the board width is set
to the minimum value (30 mm), then put it into the center part.
2) Adjust the board transport width to the minimum value (30 mm), and paste
filament tapes approximately in the middle of the screw shaft and the guide
shaft (two positions) (see Figures 1-1 and 2-1).
Rail plate M
Rail plate F
! CAUTION
b. Right And Left Edges
1) Put air cap which can be crashed easily into the protruded parts from the main
unit.
2) Wrap the air cap around the protruded parts as indicated in Figure 2-2.
! CAUTION
300
Air cap
Filament tapes (two positions)
Figure2.1
Make sure that the rail plate (black part) receives no load. If the rail
plate is deformed, the machine cannot operate normally.
q
w
Figure3.2
Make sure that the rail plate (black part) receives no load. If the rail
plate is deformed, the machine cannot operate.
- -
6
*Note that the air cap should not
touch any sensor.
Move these plates until the board
transport width becomes the
minimum value (30 mm).
Filament tapes
e