Interface With External Equipment - JUKI KE-750 Setup Manual

8.

Interface with External Equipment

q is the READY OUT (IN) connector (14-pin) to be connected to external equipment
1)
when you use the machine as inline.
the board transport direction;
and Table 1-4-2 .
w is the connector (50-pin) for the signal from/to an optional matrix tray changer.
2)
e is the power connector (10-pin) (AC 100 V) for an optional matrix tray changer.
3)
r is the printer connector (D-Sub, 25-pin) and conforms to the Centronics standard.
4)
Figure 8.1 Front left side of the main unit
left to right or right to left as indicated in Table 1-4-1
q
The pin assignment is different depending on
q
Figure8.2 Front right side of the main unit
- -
14
Breaker
r
Light
w
e