Hardware Installation - Advantech PCIE-1758 Series User Manual

2.3

Hardware Installation

Note! Ensure that all relevant drivers are installed before installing the card
(please refer to Chapter 2.2 Driver Installation).
After the device drivers are installed, the PCIE-1758 series card can be installed in
any slot on the computer. However, we recommend that you refer to the computer's
user manual or related documentation for guidance. Follow the steps provided below
to install the card in your computer.
1. Power off the computer and unplug the power cord and cables before installing
or removing any components.
2. Remove the cover of the computer.
3. Remove the slot cover on the back panel of the computer.
4. Touch a metal surface of the computer to neutralize any static electricity that
may be in your body.
5. Insert the PCIE-1758 series card into a PCI Express slot. Hold the card by its
edges only and carefully align it with the slot. Push the card firmly to insert the
card in the slot. Do not use excessive force to avoid damaging the card.
6. Fasten the bracket of the PCI Express card onto the back panel rail of the com-
puter using screws.
7. Connect any additional accessories (100-pin cable, wiring terminals, etc. if nec-
essary) to the PCIE-1758 series card.
8. Replace the cover of the computer chassis. Reconnect the cables removed in
Step 2.
9. Plug in the power cord and turn on the computer.
After the PCIE-1758 series card is successfully installed, users can begin configuring
their device using the Advantech Navigator program automatically installed during
driver setup.
9 PCIE-1758 Series User Manual