Error Messages - EWM alpha Q 352 puls MM Operating Instructions Manual

7.2

Error messages

All products are subject to rigorous production checks and final checks. If, despite this, something fails to
work at any time, please check the product using the following flowchart. If none of the fault rectification
procedures described leads to the correct functioning of the product, please inform your authorised
dealer.
The error code is signalled via the robot interface!
•
If multiple errors occur, these are displayed in succession.
•
Document machine errors and inform service staff as necessary.
General system errors
1
4
5
6
7
8
9
10
11
12
13
099-005366-EW501
31.07.2014
The change of application signal of the power
source has not been updated.
Wire feed error
Inverter/inverter emergency stop circuit
temperature error
Excess mains voltage
Insufficient mains voltage
Low water level
Gas error
Excess secondary circuit voltage
Protective conductor error
System quick stop
Internal error, please contact EWM
NOTE
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Phoenix/alpha Q/Te
trix
Rectifying faults
Error messages
Yes
Yes
No, automatic reset
No, switch off
power source
No, switch off
power source
No, switch off
power source
Yes
No, switch off
power source
No, switch off
power source
Yes
No, switch off
power source
75