Machine Control - Operating Elements - EWM alpha Q 352 puls MM Operating Instructions Manual

4.3 Machine control – Operating elements
The device controller may be installed both in an external wired remote Control as well
as in the power source!
Item Symbol
1
2
3
4
5
099-005366-EW501
31.07.2014
Machine description – quick overview
Description 0
Buttons switching digital display, left
Welding current (nominal, actual and hold values)
Material thickness (nominal value)
Wire speed (nominal, actual and hold values)
Operating hour counter
Selection of further welding parameters in lower programming levels.
Display, 16-digit
Display of all welding parameters and their values
Switching of the digital display Buttons, right
Welding voltage (nominal / actual values)
Motor current (actual value)
JOB number
After each completed welding process, the last parameter values used for the
welding process are shown on the display in the main program; the signal
light is on.
Status
Display of the current parameters specified by the robot control.
Non-latched
Special, non-latched
Pulse welding
Standard welding
Button, Mode
Select further programming levels
(program steps mode, main program A mode, JOB Manager, JOB Info)
Machine control – Operating elements
NOTE
Figure 4-3
21