Receive Channel Free Buffer Count Registers (Rx0Freebuffer-Rx7Freebuffer); Receive Channel N Free Buffer Count Register (Rxnfreebuffer); Receive Channel N Free Buffer Count Register (Rxnfreebuffer) Field Descriptions - Texas Instruments TMS320C674X User Manual

www.ti.com

5.28 Receive Channel Free Buffer Count Registers (RX0FREEBUFFER-RX7FREEBUFFER)

The receive channel 0-7 free buffer count register (RXnFREEBUFFER) is shown in
described in Table
Figure 66. Receive Channel n Free Buffer Count Register (RXnFREEBUFFER)
31
15
LEGEND: R = Read only; WI = Write to increment; -n = value after reset
Table 65. Receive Channel n Free Buffer Count Register (RXnFREEBUFFER) Field Descriptions
Bit Field
31-16 Reserved
15-0 RXnFREEBUF
SPRUFL5B – April 2011
Submit Documentation Feedback
65.
RXnFREEBUF
Value Description
0 Reserved
0-FFh Receive free buffer count. These bits contain the count of free buffers available. The
RXFILTERTHRESH value is compared with this field to determine if low priority frames should be
filtered. The RXnFLOWTHRESH value is compared with this field to determine if receive flow
control should be issued against incoming packets (if enabled). This is a write-to-increment field.
This field rolls over to 0 on overflow.
If hardware flow control or QOS is used, the host must initialize this field to the number of available
buffers (one register per channel). The EMAC decrements the associated channel register for each
received frame by the number of buffers in the received frame. The host must write this field with
the number of buffers that have been freed due to host processing.
© 2011, Texas Instruments Incorporated
Reserved
R-0
WI-0
EMAC Module Registers
Figure 66 and
16
0
109
EMAC/MDIO Module