Keysight Technologies N9020A Installation Note page 44

Exa/mxa signal analyzer

Hide thumbs Also See for N9020A:

Installation Procedure

7. Refer to

Figure

31. To pair the AIF and DIF together again, set the DIF (2) in position over the

AIF (1). Attach the AIF to the DIF with three screws (3) (0515-0372) included in the kit.

Torque to 9 inch-pounds, starting with the middle screw.

Figure 31

AIF/DIF Pairing

8. Connect the ribbon cable W2 to J820 on the AIF (1).

9. Slide the AIF/DIF assembly into the slot at the rear of the instrument and push on the

assembly to mate the connectors to the motherboard assembly.

Installation Note N9010-90054

Table of Contents

N9010a